![]() ![]() Improved quick-control puck with rotary dial.BenQ Uniformity Technology (color uniformity across the screen).These are the main improvements cited by BenQ: There wasn’t a lot of room for improvement in the SW2700PT, which is good, because not much has changed. Try to figure if you changed some sharpness setting when you reset all to factory.About a year and a half ago, I reviewed the BenQ SW2700PT monitor and found it to be excellent, but BenQ has recently released the SW270C as a replacement for that model, so I thought I’d better check it out. If text issues are there, it’s monitor fault, not related to GPU calibration. That one is the closest to you actual backligt technology (RGBLED red is different from those QLED so let’s hope that your X is not too off from CIE 1931 2 degree observer on red)ĪFIAK text should be horrible too without GPU calibration applied (tray app -> reset video card app). SpyderX should have some static/matrix correction for “RGB LED” or something close to that name. It is some LED widegamut variant or QLED or GB-LED or WLED PFS, hence correction choice is wrong => whitepoint may be wrong.Īctually looks like a QLED used in AHVA lowcost widegamuts like those from Benq:īut you cannot use them… an extremely limited colorimeter you chose. It is not a “White LED”, not the type of white led any calibration software will expect. With X your are limited to whatever toy matrix corrections are bundled on factory or to buy/rent an spectrophotometer for each new display you need to measure.Īlso is a poor performer in low light as any other Spyder. One of the most useful features of Displa圜AL is to use spectral corrections for present or future backlight technologies, official (Xrite) or community. i1d3 plays on another leage and its future proof. It’s not about brands, it’s about technlogy itself. I tried with Windows Cleartype, but the situation has not gotten better sadly. The text in all of the software has visible chromatic aberration, a strange glow on the outside and it’s very “thin”. After the calibration finished, the colors seems ok, but the text looks terrible.Calibrated by choosing 6500K and 120 cd\m2 on the software, and White LED as mode, with dim ambient light.Reset the OSD of my monitor and this time instead of Standard mode, which I used for 3 years, went to Darkroom mode.Installed Displa圜al and Argyll drivers.Uninstalled everything from previous Spyder5 (drivers and software).Any X-rite product cost almost 2,5 times it (at time of writing, it costs 248 euros). After switching from Spyder 4 to 5, all my albums and prints where perfect, and I bought this SpyderX pro at 99 euros. This reply was modified 3 years ago by Vincent.įor Spyder vs X-rite, I’m not a “fan” of brands. Do not forget that: each OSD mode => its own profile AFAIK those Asus have 2 “user modes” in OSD(D65 white and D50 white for user mode 1
0 Comments
Leave a Reply. |